ALDI Auto XS CPL 2054 User Manual download pdf (Page 14)

AFTER SALES SUPPORT

Aus

Charging program

Special charging program for vehicle batteries

from 14 to 120 Ah at lower temperatures of below

0°C. Ecient charging due to higher charging

voltage and higher charging current (14,7 V / 3,8 A).

Once the program has been selected and started

using the MODE key (7), the program symbol

appears on the display.

3.5 Disconnecting the charger

Note

The easiest method is to exactly reverse the steps used for connecting the

charger.

Caution

First pull the plug out of the mains socket and observe the correct sequence

when removing the terminal clamps. Avoid the formation of sparks.

This is extremely important for your own protection as highly explosive gas

can be produced during charging.

Disconnect charger from mains.

Next, remove battery clamp from negative terminal of battery (black clamp) or clamp

connected to vehicle chassis.

Then remove battery clamp from positive terminal of battery (red clamp) or clamp

connected to the battery.

The voltage display shows the current

voltage of the battery.

The battery symbol on the display shows the

charging condition of the battery.

The lled bars show the existing capacity, whilst

the empty bars show the missing charge. The as-

hing frame around the battery symbol indicates

that the battery is charging.

The battery is fully charged when all bars are lled,

and the frame has stopped ashing. The charger

then switches to trickle charging to maintain the

battery in its fully charged condition.

1 2 ... 9 10 11 12 13 14 15 16 17 18

No comments

ALDI Auto XS CPL 2054 User Manual Page 14